Infinity Chinese Miracle-2 MTK/Mediatek v2.01 - LEGACY support and other features
Important:
- Software installed to new folder /CM2MT2/ and designed to support new models
Identify: full device info, security infoFlash Factory FirmwareRead Factory FirmwareReset Settings / Format FSReset FRPRepair Security (Flash Mode, Direct)SP unlockMemoryTool - complete device control, service, repair, forensic etc.
- MainLoader database optimized, size reduced.DA v1820 line support tested and activatedDA v1836 line support tested and activatedConnection level revisedBROM level support optimizedOptimized and changed HighSpeed port selectionFlashEngine revisedNVRAM tool revisedGlobal option PWM - allow switch SW between two different work modes for RAPHAEL.> Use second one if first mode give errors at writing f.e. restore NVRAM on F5 like device etc.> For LEGACY phone it used in MEMORY TOOL ( WRITE / WIPE )
- ServiceRepair Security revised> Old LEGACY types require FORMAT FS/FACTORY RESET for accept changes !Format FS - new mode activated: Forced EraseFormat FS - fixed WIPE mode
- CoreEMIDB updatedNew EMI engine for LEGACY line> EMI engine support almost all existing LEGACY line> New types for RAPHAEL included
- FW readerLEGACY core supported ( unsigned and static signed types are supported )New types of firmwares supportedScatter creation optimized
- OtherSettings tab activated ( firmware path settings and other features can be found here )AutoUpdate ( module files ) feature activated
Many other changes and fixes
Known issues/warnings/info:1. FileSystem flashing on some SBC-enabled RAPHAEL devices (except SYSTEM/CACHE/USER) may fail ! Solution - exclude them from flashing list.2. Meizu support is limited by Preloader Level ( No BROM SLA ) - you must UNTICK "PMT Update" and "PRELOADER" partition from flashing list !3. MT6589 supported ONLY up to DAv17xx line, after DAv1728 support has been removed.4. MT6592 support on DAv18xx loader line broken ( DA issue )5. EMI/DRAM init module in LEGACY line is almost auto, but in some case require CHANGE EMI setting, if used internal DB ( since much RAMsize/Revision of eMMC/eMCP )6. MOST of LEGACY phone can be booted via BROM mode from now ( PLAIN, PRL, SBC )7. NAND support on LEGACY line is not activated yet
إرسال تعليق