MTF-Huawei Module 1.0 – Sigmakey Needed
Action Plan: FRP Reset and Fastboot Format
The purpose is to use MTF-Huawei Module 1.0 to reset the factory reset process on a Huawei device. But be aware that times the device can continue to show the logo or become stuck even after completing a format. If so, you must take more steps to get free of the FRP and make sure the device is completely reset.
Step-by-Step Guide
Test 1: FRP Reset and Fastboot Format
-
Prepare the Device:
- First, put your Huawei device into Huawei COM 1.0 mode via the test point method using a modified USB cable. This will allow your SigmaBox to communicate with the device at a low level for the operations.
-
Open SigmaKey:
- Launch SigmaKey on your computer.
-
Select the Platform and Port:
- In SigmaKey, select the following:
- Platform: Hisilicon
- Port: Choose the correct port that corresponds to the connected Huawei device.
- Processor: Select Kirin.
- In SigmaKey, select the following:
-
Load Fastboot:
- In SigmaKey, select Load Fastboot. This will prepare the device for further actions and establish a fastboot connection.
Wait for the system to establish the fastboot connection...
-
Open the MTF-Huawei Module 1.0:
- Once the connection is successful, open the MTF-Huawei Module 1.0.
-
Perform Fastboot Format:
- On the MTF-Huawei Module, press 2 to initiate the fastboot format process.
- Wait for the process to complete.
In case the device logo is still visible:
- If the logo remains after the format, the next step will be to enter recovery mode and perform a low-level format.
Step 2: Recovery Mode Format
If you notice that the device still shows the logo or gets stuck, follow these additional steps to complete the FRP reset and fastboot format.
-
Put the Device into Huawei COM 1.0 Mode:
- Again, connect the phone using the test point method with the modified USB cable.
-
Reopen SigmaKey:
- Launch SigmaKey again.
-
Select Platform, Port, and Processor:
- Make sure to select the same platform (Hisilicon), port, and processor (Kirin) as before.
-
Load Fastboot:
- Choose Load Fastboot once more to re-establish the fastboot mode connection.
Wait for the system to recognize the device.
-
Remove FRP:
- On the SigmaKey interface, select the option Remove FRP.
- Wait for the tool to proceed with the FRP removal.
-
Wait for the Process to Finish:
- Once the FRP removal process is completed, your device should be free from the Google account lock (FRP).
إرسال تعليق